Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 3)

Connecting a single monitor
Connecting a monitor to your Power Macintosh 4400
Before you begin, make sure your computer and monitor are unplugged. Then
follow these steps using the loopback cable:
Plug the middle connector on the
loopback cable into the left port
on your PC Compatibility Card. This
connector has a triple row of pins and
an Apple (
K
) icon on either side.
Plug the long connector on the loopback
cable into the built-in monitor port
(or video card if one is installed).
Plug the short connector on the loopback
cable into your monitor’s cable. This connector
has an Apple (
K
) icon on one side and
a monitor ( ™ ) icon on the other.
1
2
3
3 Connecting Monitors and Other Equipment
WARNING Do not plug a monitor into the joystick port (marked with the
icon ), and do not plug a joystick into a monitor port (marked with the
icon
™). Serious damage can result to your equipment.