Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 143)

11 Refer to “Running the Network Protocol Setup (SETNET) Utility,” next, and follow the
instructions there.
12 After running SETNET, make sure your PROTOCOL.INI file contains the following
(assuming TCP/IP is the only loaded protocol):
PROTOCOL.INI
[ndishlp$]
DriverName=ndishlp$
Bindings=MacNDIS$
[protman$]
DriverName=protman$
priority=ndishlp$
[data]
version=v4.00.950
netcards=MacNDIS$,MacNDIS
[MacNDIS$]
DriverName=MacNDIS$
ProtocolDIX=”800,806,8035”
13 Shut down Windows 95.
14 Switch to the Mac OS by pressing
x
-Return.
15 Click Restart PC in the PC Setup control panel.
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
143 Installing Network Client Software