Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 19)

19 Installing the PC Compatibility Card Software
m Do not install any networking software during the Windows 95 installation
process. To install networking software, see Appendix D, “Installing
Network Client Software,” after you have completed the Windows 95 setup
process.
m At the end of the installation process, make sure to eject the Microsoft
Windows 95 CD-ROM Setup Boot Disk by pressing
x-E before the computer
restarts. If the Microsoft Windows 95 CD-ROM Setup Boot Disk is still in the
disk drive, the computer will boot from the floppy disk when it restarts.
When the installation process is complete, the PC environment automatically
restarts and runs Windows 95.
6 Follow the onscreen instructions to complete the Windows 95 setup.
The first time you run Windows 95 after installation, the Windows 95 setup
program automatically starts. Follow the instructions on the screen noting the
following items:
m When you are asked to install printer drivers, click Cancel. To set up
printing, see Chapter 3, “Setting Up the PC Environment,” after you have
completed the Windows 95 setup process.
m Do not print the test page if you are prompted to do so.