Buhler 2180 - Manual (Page 95)

SECTION 2 - OPERATION
2-49
STARTING THE ENGINE AND MOVING
FORWARD
There are two methods:
1. Preselect A Forward Gear Before Moving
Start the engine with the speed control lever in
neutral (the digital display will show “N5”).
Move and release or hold the control lever to the right
and allow the transmission to select any gear
between 5th and 10th as shown in the display. (10th
gear is the highest available gear for moving from a
standstill).
To start in a gear below 5th, move and release or hold
the control lever to the left and allow the display to
change sequentially from 5th down to 1st.
78
After the desired gear is selected, increase engine
speed, as required, by means of the throttle. Depress
the neutral lock button and move the control lever
forward. To increase tractor speed, open the throttle
further and/or continue to move and release or hold
the control lever to the right to select a higher gear.
To decrease speed, close the throttle and/or move
the control lever to the left to select a lower gear.
79