Buhler 2180 - Manual (Page 234)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-46
EVERY 900 HOURS OR 12 MONTHS (WHICHEVER OCCURS FIRST)
OPERATION 51
CHANGE TRANSMISSION OIL FILTER
NOTE: Perform this operation while oil is drained in
“Operation 49.”
NOTE: Clean filter area before proceeding.
To change the filter:
1. Remove the filter, 1. Dispose of filter properly.
2. Discard the O ring, 2.
3. Clean the filter manifold seal surface, 3.
4. Coat the new O ring, 2, with clean oil.
5. Install the filter and tighten.
82
OPERATION 52
CHANGE HYDRAULIC OIL FILTER
NOTE: Perform this operation while oil is drained in
“Operation 49.”
NOTE: Clean filter area before proceeding.
To change the filter:
1. Remove the filter, 1. Dispose of filter properly.
2. Discard the O ring, 2.
3. Clean the filter manifold seal surface, 3.
4. Coat the new O ring, 2, with clean oil.
5. Install the filter and tighten.
IMPORTANT: Be sure to install the correct size filter.
83