Buhler 2180 - Manual (Page 309)

5-37
OWNER COPY
FIRST 50--HOUR SERVICE
STATIONARY CHECKS – ENGINE OFF:
_____ 1. Tire pressures and condition
_____ 2. Radiator coolant level and specific gravity
1.071 – 1.083 at 16° C (60° F)
_____ 3. Poly V Belt
_____ 4. Engine oil and filter change
_____ 5. Change Diesel fuel filter, clean fuel
sedimenter, and bleed system
_____ 6. Change transmission filter
_____ 7. Change Hydraulic filter
_____ 8. Air cleaner element and hose connections
_____ 9. Coolant lines and clamps
_____ 10. Windshield wiper/operation and washer
fluid level
_____ 11. Transmission/rear axle oil level
_____ 12. Change front axle differential oil (FWD)
_____ 13. Change front axle hub oil (FWD)
_____ 14. Wheel--to--rim hardware torque
_____ 15. Wheel disc--to--hub hardware torque
_____ 16. Front end weight clamp bolts for tightness
_____ 17. Front wheel toe--in & steering stops
_____ 18. Check adjustment of front wheel bearings
(two--wheel drive only)
_____ 19. Lubricate all grease fittings
_____ 20. Seat operation
_____ 21. All electrical cables, terminals and wires
_____ 22. Exhaust manifold bolt torque
_____ 23. Clean cab air filter
SAFETY ITEMS CHECKS:
All operative checks are to be performed with the tractor
at normal operating temperature:
STATIONARY CHECKS – ENGINE RUNNING:
_____ 1. Lights and instruments for proper operation
_____ 2. Fluid and oil leaks
_____ 3. Maximum no--load speed and idle speed
adjustments
_____ 4. PTO operation & brake
5. Hydraulic System:
___ Selector lever & knobs for draft and
position control operation
___ Draft control operation
___ Remote control valves
___ Flow control operation
___ Pressure detent operation
_____ 6. Transmission selector & EIC gear display
_____ 7. Calibrate transmission directional clutches
_____ F1 _____ F2 _____ Rev
PERFORMANCE SERVICE CHECKS
_____ 1. Road test engine operation including
throttle and governor operation
_____ 2. Transmission, transmission programming
_____ 3. Steering control
_____ 4. Differential lock and FWD engagement
and disengagement
_____ 5. Brake action
_____ 6. All optional equipment and accessories
NOTE: Engines are filled with 10W--30 at the factory.
The oil must be changed after the first 50 hours of
operation. Change oil and filter.
_____ 1. Seat belt operation
_____ 2. All Safety shields installed
_____ 3. Neutral start switches operative
_____ 4. Parking brake operation & adjustment
_____ 5. Battery Cables
_____ 6. Cab bolt torque