Buhler 2180 - Manual (Page 52)

SECTION 2 - OPERATION
2-6
Steering Wheel Telescopic Adjustment
Rotating the center locking knob, 1, counterclock-
wise, will unlock the steering column so the steering
wheel, 2, can be moved fore or aft (telescoped) to a
comfortable operating position. Tighten in place by
rotating the locking knob clockwise.
IMPORTANT: Your tractor is equipped with
hydrostatic power steering. Never hold the steering
wheel against either of the steering stops for more
than 10 seconds or for more than a total of 10
seconds in any one minute. Failure to observe this
precaution may result in damage to the steering
system components.
7
RIGHT-HAND CONSOLE
The console can be moved full forward, 1, and full
rearward, 2, or stopped anywhere in between to
position the controls on the console in a comfortable
operator position.
NOTE: When the console is moved aft, the front of
the console also moves away from the seat. This
provides additional leg room while maintaining the
controls in a comfortable position when the seat is
swiveled to the right.
Press and hold the front of the console control switch,
3, to move the console forward. Release the switch
when the desired position is obtained or when the
console reaches the limit of forward travel.
Press and hold the rear of the switch for aft
movement. Release the switch at the desired
position or at the end of aft travel.
2
1
3
8