Buhler 2180 - Manual (Page 80)

SECTION 2 - OPERATION
2-34
To program the Service Alert Indicator II, the process
is the same as for Service Alert I, but when the SET
UP/SELECT switch, 3, is touched, the left digits, 1,
will be “II.” The next digit, 2, will be flashing indicating
that the operator can now program the 300-hour
Service Alert Interval II.
51
CANCEL FLASHING SERVICE INDICATOR
To identify which service is due and to cancel the alert
after the service has been completed, reenter the
service alert programming menu. If the word
“SERVICE,” 1, is flashing and a single I is displayed,
complete the 50-hour service as described in the
“Lubrication and Maintenance” section and cancel
the alert by holding the START/STOP, RESET
switch, 3, for three seconds.
The left digit will begin flashing indicating that the
service hour interval can now be changed. If no
change is desired, touch the SET UP/SELECT
switch, 4, to select the service alert II indicator. If the
word “SERVICE”, 1, is flashing and II, 5, is displayed,
the 300-hour service, 2, is required. To cancel the
alert after the service has been completed, hold the
START/STOP, RESET switch, 3, for three seconds.
NOTE: If the START/STOP, RESET switch, 3, is held
for an additional three seconds, the previously stored
service alert interval will be reset to 0. To reprogram
a new interval, review the previous programming
steps.
After the service intervals have been entered, touch
the SET UP/SELECT switch, 4, to view and change
the Ground Speed Calibration constant.
52