Buhler 2180 - Manual (Page 73)

SECTION 2 - OPERATION
2-27
AUTOMATIC DISPLAY INFORMATION
The following information is automatically displayed:
Hitch Disabled Symbol (with 3-point Hitch only)
The hitch disabled symbol, 1, is displayed when the
3-point linkage is out of phase with the 3-point hitch
control lever. See “3-Point Hitch Control” later in this
section.
NOTE: If the Hitch Disabled Symbol is flashing, a
fault has occurred. The 3-point hitch warning light will
also be flashing on the right-hand console which
requires attention before proper operation of the
tractor hitch can occur. See “Fault Code Indicator”
later on this page.
Hitch Position Display (with 3-point Hitch only)
This display, 2, advises the operator of the relative
position of the lower links (and implement) by means
of numbers ranging from “0” (fully lowered position)
to “99” (maximum height position.) See “3-point Hitch
Control” later in this section.
Hitch Enabled Symbol (with 3-point Hitch only)
The hitch enabled symbol, 3, is displayed to advise
the operator when the 3-point linkage is in phase with
the 3-point hitch control lever. See “3-Point Hitch
Control” later in this section.
Fault Code Indicator
In the event that a fault occurs within the tractor’s
electrical circuits, a malfunction warning symbol
“READ YOUR MANUAL,” 4, will flash on and off.
Fault codes can be reviewed using the procedure
detailed in the “EIC-Programming” section later in
this section.
If the fault code indicator or fault codes are displayed,
refer to the “EIC Programming” section for
information on retrieving and clearing the display.
37