Buhler 2180 User Manual
Page 270
SECTION 4 - TROUBLESHOOTING
4-8
3-POINT HITCH
PROBLEM
POSSIBLE CAUSE
CORRECTION
Hitch does not move when control
lever is moved
Hitch not in phase with control
lever
Work/raise switch in raise position
Malfunction in lever position or
hitch position sensor
Excessive load on hitch
Height limit control not properly
adjusted
Capture the hitch
Position switch in the work position
See your authorized dealer
Reduce load
Adjust upper height limit control
Rear fender raise/lower switches
do not function
Work/raise switch in raise position
Control lever not positioned full
forward
Position switch in the work position
Push lever full forward
Hitch does not fully raise
Upper height limit control not
correctly set
Adjust height limit control
Hitch drops slowly
Drop rate control not properly
adjusted
Adjust drop control
Hitch slow to respond to draft load Position/draft mix control not
properly adjusted
Drop rate too slow
Implement not working properly
Adjust position/draft mix control
Adjust drop rate control
See implement operator’s manual
Hitch over responsive to draft load Position/draft mix control not
properly adjusted
Adjust position/draft mix control
Hitch
status
light
flashes
continually
Malfunctioning hitch component(s) See “Fault Codes ON/OFF” and
your authorized dealer