Buhler 2180 User Manual
Page 260
SECTION 3 - LUBRICATION AND MAINTENANCE
3-72
GENERAL MAINTENANCE
OPERATION 70
REPLACE THE FENDER MOUNTED TURN
SIGNAL AND STOP LIGHT/ PARKING
LIGHT BULBS
The turn signal bulbs, 3, are behind the amber
lenses. The stop light and parking light bulbs, 2, are
behind the red lenses on the rear fenders.
To replace the bulbs:
1. Remove the retaining screws, 1.
2. Remove the lens.
3. Remove the failed bulb by pressing the bulb in
and turning it counterclockwise.
4. Install a new bulb by pushing the bulb in and
turning it clockwise until it locks in place.
5. Replace the lens and tighten the retaining
screws, while being careful to fit lens properly
into the rubber gasket base.
124
OPERATION 71
REPLACE ROOF MOUNTED TURN SIGNAL
BULBS
To replace the bulb:
1. Remove the retaining screws, 1, then remove the
lens, 2.
2. Remove the bulb, 3, by pressing the bulb in and
turning it counterclockwise.
3. Install a new bulb by pushing the bulb in and
turning it clockwise until it locks in place.
4. Replace the lens and tighten the two screws.
IMPORTANT: When replacing the lens, do not
overtighten the retaining screws.
NOTE: The lens must fit inside the rubber seal, 4, to
ensure a waterproof fit.
125