Buhler 2180 - Manual (Page 164)

SECTION 2 - OPERATION
2-118
WHEEL TOE-IN (FWD)
Checking Toe-in On Standard and
UltraSteer Axles
Use the following procedure to check and adjust
toe-in:
The correct toe-in is 0 mm - 6 mm (0″ - 1/4″).
1. Position the front wheels straight ahead.
2. Mark the inside front of each rim at hub height.
Mark the rim where the tire and rim meet.
3. Measure the distance, 1, between the two marks.
4. Drive the tractor forward until the tires rotate 180
degrees and the marks are at hub height at the
rear of the wheels.
5. Measure the distance, 2, between the two marks.
6. Subtract the front measurement from the rear
measurement to get the toe-in.
7. The toe-in should be 0 mm - 6 mm (0″ - 1/4″).
If adjustment is required, proceed to the procedure
for the style FWD axle installed.
176
Adjusting Toe-in - Standard steer FWD
To adjust the toe-in:
1. Loosen the jam nuts, 1, on each side of the tie
rod.
2. Turn the tie rod tube, 2, to adjust the toe-in to
0 mm - 6 mm (0″ - 1/4″).
3. Tighten the jam nuts, 1, on each side of the tie
rod.
4. Check the adjustment of the steering stops.
1
1 2
177