Buhler 2180 User Manual
Page 112
SECTION 2 - OPERATION
2-66
STOPPING THE ENGINE
NOTE: Before stopping, idle the engine at 1000 rpm
for approximately one minute. This will allow the
turbocharger and manifold to cool and prevent
possible distortion of components.
WARNING
Check the area beneath the equipment to make
sure that no injury or damage will be caused
when equipment is lowered. Do not exit the
tractor until pto driven equipment has stopped.
To stop the engine, carry out the following procedure:
1. Sit in the driver’s seat.
2. Move the powershift control lever to “NEUTRAL.”
3. Disengage the PTO, if engaged.
4. Lower all hydraulic equipment to the ground.
5. Position all remote control valve levers in the
neutral position.
6. Return the throttle to idle speed.
7. Apply the parking brake.
8. Turn the KEY-START switch to “OFF,” (position 1).
101