Buhler 2180 - Manual (Page 140)

SECTION 2 - OPERATION
2-94
3-POINT HITCH FLOAT
When To Use Float
Float should be used when the attachments depth
position is controlled by gauge wheels or some other
device that controls implement depth while following
ground contour. Your GENESIS tractor has 3-point
hitch float capability. Float is obtained by manually
positioning the 3-point arm attaching pins in the float
position, 3. (Lockplate vertical)
1. Clevis
2. Lock pin
3. Lock plate
4. Lower links
Setting the 3-Point Hitch For The Float Position
To conserve engine power, reduce hydraulic load,
minimize heat in the hydraulic system and get
maximum implement performance, follow these
simple steps when using 3-point float.
1. Manually position the 3-point arm pins in the float
position, 3.
1
2
3
4
134
2. Rotate the position/draft control knob, 3, if
equipped, to full position control by rotating the
knob fully counter-clockwise into the detent
position.
NOTE: Only use full position control when operating
in float position.
3. Place the 3-point control lever, 1, fully forward
and operate the implement in the field until the
gauge wheels control the implement’s depth,
then stop the tractor.
4. Slowly move the 3-point lift control lever rearward
until the 3-point arms are in the middle of the float
slot.
5. With the arms set in the middle of the float slot,
adjust the 3-point lever stop, 2, against the lever,
1. Always position the lever against the stop
when operating with the implement in the ground.
1
3
2
135
6. After setting the 3-point control lever position and
stop, use the 3-point fast raise/lower rocker
switch, 1, to raise and lower the hitch at the end
of the field or for transport.
136