Buhler 2180 - Manual (Page 142)

SECTION 2 - OPERATION
2-96
Position/Draft Control Test
To determine if position control or draft control is
needed for an application, perform the following test.
1. Attach and adjust the implement as described in
the implement operator’s manual.
2. Turn the position/draft sensitivity control knob, 1,
to position. Control (counterclockwise).
1
140
3. Set the lower link lock plate in the position
configuration, 2, (horizontal).
4. During normal field operation, use the lift control
lever to engage the implement into the ground
until, the desired depth is obtained, the tractor
stalls, or looses traction and spins out.
If the desired depth is obtained and maintained
without the tractor stalling or loosing traction then
position control should be used.
If the tractor stalls or spins out while trying to
obtain the desired operating depth then draft
control should be used.
NOTE: The use of this test is only a guide for
determining if position or draft control on ground
engaging implements should be used.
1
2
3
4
141