Boss Audio Systems DIGITAL RECORDING STUDIO BR-1600CD - Manual (Page 8)

8
Before Using CD-R/RW Discs
Compatibility of CD-R/RW
discs and drives
● Ensure that the recommended type of CD-R/RW discs
are always used. Failure to observe this precaution can
lead to an increase in the frequency of write errors.
● Even when the recommended type of disc is used, there
is still a possibility that write errors can occur. Please be
aware that this type of problem can still result from
variations in CD-R/RW drives and CD-R/RW disc
manufacturing differences.
● The usage of discs with printable labels is not
recommended, even if these discs are of the
recommended type. Certain storage conditions can cause
discs with printable labels to warp, and write errors can
occur as a result.
When you insert a CD-R/RW disc to
built in CD-R/RW drive...
When you insert a CD-R/RW disc to built in CD-R/RW
drive, lock the CD-R/RW disc at correct position according
to “Insert a CD-R/RW disc” below. Please be careful to lock a
CD-R/RW disc correctly. Unless, it is possible that the disc
tray is stuck and unable to remove a CD-R/RW disc.
Inserting a CD-R/RW disc
1. Press the eject button and open a disc tray.
2. Pull out a disc tray.
3. Locate the position of center hole of CD-R/RW disc at
stopper of CD-R/RW drive.
4. Press the CD-R/RW disc downward. The CD-R/RW
disc will be locked by 3 clips of the stopper.
fig.CD set
* As a certain amount of force must be applied for insertion,
always confirm that the CD-R/RW disc has been correctly
inserted. Failure to properly and fully insert a disc can result
in an inability to carry out writing correctly.
5. Press disc tray until it is locked in the BR-1600CD.
Removing a CD-R/RW disc
1. Hold the stopper downward and remove a CD-R/RW
disc from outer rim.
fig.CD eject
If a disc tray does not open
If the power is turned off with the disc still in the drive (such
as due to a power failure), the disc tray cannot be opened by
pressing the eject button. In this case, you can insert a piece
of wire to force the tray open.
fig.Hole
Make sure the BR-1600CD’s power has been turned OFF
before attempting to use the emergency eject hole. If you
insert something while the power is on, the disc could get
damaged, or unexpected problems may occur.
Emergency Eject Hole
BR-1600_R_e.book 8 ページ ２００７年１２月６日 木曜日 午前９時５２分