Boss Audio Systems DIGITAL RECORDING STUDIO BR-1600CD - Manual (Page 278)

278
Error Messages
Event Memory Full!
Cause: The BR-1600CD has used up all the events that
can be handled by one song.
Action: Perform the Song Optimize operation. (p. 70)
Finalized Disc!
Cause: Data has already been written to the CD-R/RW
disc, and the data has been finalized.
Action: Place a CD-R/RW disc that has not been finalized
in the drive.
HDD Damaged! Can't Access HDD.
Cause: Data could not be read from or written to the hard
disk.
Action: There is a possibility that the hard disk has been
damaged. Shut down the BR-1600CD as instructed
and send it for repair.
HDD Full!
Cause: There is insufficient free space on the hard disk.
Action 1: Erase unneeded data.
Action 2: Perform the Song Optimize operation. (p. 70)
HDD Read Error!
Cause: An error occurred while reading data from the
hard disk.
Action: The hard disk must be initialized (p. 270).
HDD Write Error!
Cause: An error occurred while writing data to the hard
disk.
Action: The hard disk must be initialized. Also, the song
data you had been attempting to save will be lost.
Insert Disc #***!
Cause: During recovery of backup data located on
multiple CD-R/RW discs, the disc of the
requested number was not placed in the drive.
Action: Place the disc with the requested number in the
drive.
Lack of Events!
Cause: It is not possible to execute Undo or Redo if
fewer than 200 events remain.
Action: Perform the Song Optimize operation. (p. 70)
Marker Memory Full!
Cause: The BR-1600CD has used up all the marker
memory (100 markers) that can be handled by one
song.
Action: Delete unneeded markers.
Medium Error!
Cause: There is a problem with the CD-R/RW disc or
hard disk. Alternatively, the disc on the CD-R/
RW drive is unreadable.
Action 1: Confirm that the correct type of disc is placed in
the CD-R/RW drive.
Action 2: Use a new CD-R/RW disc.
Action 3: Use the following procedure to initialize the hard
disk.
MIDI Error!
Cause 1: Active Sensing is on, and it has detected that no
MIDI message transmissions have taken place for
more than approximately 400 ms.
Action 1: Check the external MIDI device connected to MIDI
IN to make sure it is turned on, and that the
settings are correct. Also, confirm that the MIDI
cable has not been disconnected.
Cause 2: Processing has been overloaded due to high
volumes of MIDI messages received from the
external MIDI device.
Action 2: Reduce the amount of MIDI messages transmitted
by the external MIDI device.
No Data!
Cause 1: You attempted to modify marker or scene data
when none existed.
Cause 2: You attempted to create an audio CD with no data
in the tracks or songs, or you attempted to export
a WAV or AIFF file.
Action: First create data.
No File!
Cause 1: During a USB import operation, no file was
copied from the PC to the USB folder.
Action 1: Copy the file from the PC to the USB folder.
Cause 2: The copied file is not of WAV or AIFF format.
Action 2: Copy a file of WAV or AIFF format.
BR-1600_R_e.book 278 ページ ２００７年１２月６日 木曜日 午前９時５２分