Boss Audio Systems DIGITAL RECORDING STUDIO BR-1600CD - Manual (Page 163)

163
Section 3
Using bass
Setting the track type
To use bass, you must first of all set up Track 13/14 as a bass
track using its track type setting.
fig.20-044
1. Press [TRACK TYPE SELECT].
The Track Type Select screen will appear.
fig.20-003d
2. Press [F3].
The track type for Track 13/14 will switch each time this
button is pressed.
fig.20-046d
Track Types
AUDIO:
The track will be used for recorded audio.
BASS:
The track will be used for bass.
You should select “BASS” here.
The BASS indicator from TRACK TYPE SELECT will
light up to indicate that Track 13/14 has been set up for
use as a bass track.
3. Press [EXIT/NO] to return to the top screen.
You will now be able to use bass.
4. If you wish to store the track type setting, save the
current song (p. 72).
Playing bass
Simply changing the track type may not be sufficient to allow
bass to be played. Use the following procedure in such a
case.
1. Press the track button for Track 13/14 several times
until it lights up.
Pressing the button repeatedly allows you to cycle
through the available choices, which are: Flashing
→ On
→ Off.
Off:
No bass sounds will be played.
Flashing:
Bass sounds will be played only when the BR-1600CD is
recording or performing playback.
On:
Bass sounds will be played even when the BR-1600CD is
stopped.
2. Raise the fader for Track 13/14 to a suitable level.
You will now be able to hear the bass sounds.
1
3
2
BR-1600_R_e.book 163 ページ ２００７年１２月６日 木曜日 午前９時５２分