RADWAG BALANCES 3Y SERIES - Manual (Page 54)

- 54 -
 Time – adjustment takes place in time intervals declared in menu
(11.6)
 Temperature – adjustment is triggered by temperature change only
 Both – adjustment activation is triggered both by temperature changes
and time interval changes
CAUTION:
Changing the settings of automatic adjustment is enabled only in balances which are
not subject to conformity assessment (i.e. non-verified balances).
11.6. Automatic adjustment time
< Automatic adjustment time > determines time interval in which
automatic internal adjustment of a balance is activated. The time interval is
declared in hours and ranges between 1 and 12 hours.
Setting time interval of automatic internal adjustment:
 Select option < Automatic adjustment time >
 Using displayed menu select appropriate time interval (given in hours)
which is a time gap elapsing from the last carried out internal automatic
adjustment until activating the following automatic internal adjustment.
CAUTION:
Changing the settings of automatic adjustment is enabled only in balances which are
not subject to conformity assessment (i.e. non-verified balances).
11.7. Adjustment report printout
Parameter < Report printout > determines whether or not a report on
automatic internal adjustment should be automatically printed on its
completion.
Setting automatic report printout on adjustment completion. Go to parameter:
< Report printout > and select option .
11.8. GLP project
GLP is one of means for maintaining documentation from work in accordance
with adopted quality system. Data selected for printing are printed on each
release of a report on balance adjustment.
Balance operator can use in a GLP report below listed information and signs:
 adjustment (adjustment mode)
 working mode (name of a working mode)
 date, time,
 user,
 balance type,
 balance ID,
 level status,
 nominal mass,
 current mass
 difference
 temperature,