RADWAG BALANCES 3Y SERIES - Manual (Page 173)

- 173 -
9. Standard liquid [name of liquid used for determining density
measurement of solid object]
10. Standard liquid density [density determination of solid object]
11. Temperature [temperature of liquid used for carrying out a
measurement, density determination of solid
object]
12. Plunger volume [density determination of liquid]
13. Mass of steel standard [density determination of air]
14. Mass of aluminium standard [density determination of air]
15. Density of steel standard [density determination of air]
16. Density of aluminium standard [density determination of air]
17. Weighing 1 [mass measurement of tested sample or a
plunger in the air, or mass of measured steel
standard]
18. Weighing 2 [mass measurement of tested sample or a
plunger in liquid, or mass of measured aluminium
standard]
29.8. Controls
(not available in standard balance version)
Each product control carried out on a balance is sent to a connected printer and
saved in the < Controls>database. Each control saved in the database
features its specific number set at the moment of its completion.
Control number format:
X / y y / M M / d d / H H / m m, where:
X - control type which takes the following values:
U – control regulated by the act,
Z – control completed by a user,
W - control regulated by an internal criteria
yy – year of control end,
MM – month of control end,
dd – day of control end,
HH – hour of control end,
mm – minute of control end.
Balance user can preview data on each control.
Procedure
• Enter submenu < Databases> in accordance with point 27 of this user
manual,
• Enter < Controls>database and select a desired control record.
List of parameters defined for a control:
1. Batch number [batch no. of a controlled product]