Kramer Electronics VS-1616D - Manual (Page 41)

Using the Configuration Menus
37
37
4. Press 1 to switch Reply on or 2 to switch it off.
5. Press TAKE to confirm the action.
A message is displayed indicating the new status of the Reply configuration.
After a few seconds the next option on the Config Menu is displayed.
8.2.7 Config Menu—Protocol Switching
The VS-1616D supports Kramer Protocol 3000 and Protocol 2000.
To switch from Protocol 3000 (default) to Protocol 2000:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until the following is displayed:
PROTOCOL configuration
Current: Kramer-3000
This indicates the current Protocol setting.
3. Press ENT to enter the Reply Submenu.
The following is displayed:
PROTOCOL configuration
1:KRAMER-2000 2:KRAMER-3000
4. Press 1 to switch to Protocol 2000.
The following is displayed:
Set PROTOCOL to KRAMER-2000?
press TAKE to confirm
5. Press TAKE to confirm the action.
A message is displayed indicating the new Protocol status. After a few
seconds the next option on the Config Menu is displayed.
8.2.8 Config Menu—Store Default Setup
This option lets you store the current setup as the default setup. The default setup
can be recalled at any time using the DEFAULT SETUP button (see Section 7.4.5
Note: This is not the setup that is loaded when the unit is switched on.
).
To store the current setup as the default setup:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until the following is displayed:
store DEFAULT setup
press ENTER to store