Allied Telesis AT-S39 - Manual (Page 43)

Section II: Local and Telnet Management
43
3. From the Advanced Configuration window, type 3 to select SNMP
Configuration. The SNMP Configuration window in Figure 6 is
displayed.
Figure 6 SNMP Configuration Window
4. Adjust the parameters as desired. To change a value, type its
corresponding number and, when prompted, enter the new value.
The parameters are described below.
1 - GET Community
2 - SET Community
3- Trap Community
Use these parameters to set a switch’s SNMP community strings.
4 - Trap Receiver 1
5 - Trap Receiver 2
6 - Trap Receiver 3
7 - Trap Receiver 4
Use these selections to specify the IP addresses of up to four
management workstations on your network to receive traps from
the switch.
5. After making your changes, type S to select Save Configuration
Changes.
Changes to the SNMP parameters are immediately activated on
the switch.
Allied Telesyn AT-8024 Ethernet Switch
Login Session: Manager
SNMP Configuration
1 - GET Community .............. public
2 - SET Community .............. private
3 - Trap Community ............. public
4 - Trap Receiver 1 ............ 0.0.0.0
5 - Trap Receiver 2 ............ 0.0.0.0
6 - Trap Receiver 3 ............ 0.0.0.0
7 - Trap Receiver 4 ............ 0.0.0.0
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection: