Allied Telesis AT-S39 - Manual (Page 42)

AT-S39 User’s Guide
42
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and to assign
up to four IP addresses of management stations to receive traps from
the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
The System Configuration Menu in Figure 4 is displayed.
Figure 4 System Configuration Menu
2. From the System Configuration Menu, type A to select Advanced
Configuration.
The Advanced Configuration window in Figure 5 is displayed.
Figure 5 Advanced Configuration Window
Allied Telesyn AT-8024 Ethernet Switch
Login Session: Manager
System Config Menu
1 - MAC Aging Time ................... 300 seconds
2 - Switch Mode ...................... Tagged
3 - Console Discount Timer Interval .. 10 minute(s)
4 - Web Server Status ................ Enabled
5 - SNMP Access ...................... Enabled
6 - TFTP Server Status ............... Enabled
7 - Console Setup Mode ............... Menu
8 - Reset to Factory Defaults
A - Advanced Configuration
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection:
Allied Telesyn AT-8024 Ethernet Switch
Login Session: Manager
Advanced Configuration Menu
1 - IGMP Snooping Configuration
2 - Broadcast Timers Setup
3 - SNMP Configuration
R - Return to Previous Menu
Enter your selection: