Allied Telesis AT-S39 - Manual (Page 107)

Section II: Local and Telnet Management
107
6 - Bridge Identifier
The MAC address of the bridge. The bridge identifier is used as a
tie breaker in the selection of the root bridge when two or more
bridges have the same bridge priority value. This value cannot be
changed.
7 - Root Bridge
The MAC address of the bridge functioning as the root bridge in
the spanning tree domain. This value is for display purposes only
and cannot be changed.
8 - Root Priority
The priority number of the root bridge.
3. After adjusting the parameters, type S to select Save Configuration
Changes.
Configuring a
Port’s RSTP
Settings
To adjust a port’s RSTP parameters, perform the following procedure:
1. From the Spanning Tree Menu, type 4 to select RSTP Configuration.
2. From the RSTP Configuration menu, type P to select RSTP Port
Parameters.
The following menu is displayed:
Figure 31 RSTP Port Parameters
3. Type 1 to select Configure RSTP Port Settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
4. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Ending Port to Configure [1 to 24] ->
Allied Telesyn Ethernet Switch AT-8024
Login Session: Manager
RSTP Port Parameters
The current protocol version is RSTP.
1 - Configure RSTP Port Settings
2 - Display RSTP Port Configuration
3 - Display RSTP Port State
R - Return to Previous Menu
Enter your selection?