Allied Telesis AT-S39 - Manual (Page 142)

AT-S39 User’s Guide
142
Setting a Switch’s VLAN Mode
This section contains the procedure for setting a switch’s VLAN mode.
You can configure a switch to support port-based and tagged VLANs or
to operate in the Basic VLAN mode. Port-based and tagged VLANs and
the Basic VLAN mode are all described in earlier sections in this chapter.
To configure a switch’s VLAN mode, perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. Type 2 to select Switch Mode.
The following prompt is displayed:
Enter Switch Mode (T-Tagged, B-Basic):
3. Type T in order to create your own port-based and tagged VLANs, or
B to configure the switch for the Basic VLAN Mode. The default is
Tagged mode. Press Return.
4. Type S to select Save Configuration Changes.
5. Reset the switch using the Reset Switch option in the Administration
Menu or the reset button on the back of the unit.
A change to VLAN status is not activated until you reset the switch.