Allied Telesis AT-S39 - Manual (Page 143)

Section II: Local and Telnet Management
143
Enabling or Disabling All VLANs
This procedure performs exactly the same function as the previous
procedure. It sets a switch’s VLAN mode. When VLANs are enabled, the
switch supports port-based and tagged VLANs. When VLANs are
disabled, the switch supports the Basic VLAN mode.
The only difference between the two procedures has to do with ingress
filtering. If you activate the Basic VLAN Mode using the previous
procedure, ingress filtering is disabled. Changing the VLAN mode of a
switch using this procedure does not change the current setting of
ingress filtering.
To configure a switch’s VLAN mode, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 1 to select Virtual LAN Support.
The Virtual LAN Support menu in Figure 45 is displayed.
Figure 45 Virtual LAN Support Menu
Allied Telesyn Ethernet Switch AT-8024
Login Session: Manager
Virtual LAN Support
1 - Enable/Disable VLANs
2 - Enable/Disable Ingress Filtering
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?