Allied Telesis AT-S39 - Manual (Page 29)

Section II: Local or Telnet Management
29
Note
The switch has an auto-detect feature that automatically
determines the speed of the terminal. You use this feature by
pressing any key on your keyboard within five seconds after
powering on or resetting the switch. The switch responds by
determining the speed of the terminal and automatically
configuring the speed of the RS232 Terminal Port accordingly.
Otherwise, the switch uses a default baud rate of 9600 bits per
second (bps). The switch maintains the terminal port speed until the
system is again powered on or reset. The range of the port’s baud
rate is 1200 to 115200 bps.
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
Note
During boot up, the switch displays the following prompt: Press
any key to stop image loading and go to Boot
Prompt
. This message is intended for manufacturing purposes
only. (If you inadvertently display the boot prompt (=>), type boot
and press Return to start the switch.)
4. Press the Return key twice.
If prompted for a password, enter the password for the management
software. The default password for manager access is “admin”.
The default password for operator access is “friend”. The
passwords are case-sensitive. For information on the two access
levels, refer to Management Access Levels on page 24. (For
instructions on how to change a password, refer to Configuring
the Management Passwords on page 46.)