Allied Telesis AT-S39 - Manual (Page 198)

AT-S39 User’s Guide
198
Once the filename has been specified, the download begins.
Downloading a configuration file takes only a few moments.
Downloading an AT-S39 image file can take several minutes.
If you are installing a new management image, the switch
begins to initialize the software after it is installed, a process
that takes approximately one minute to complete. Once the
management software is initialized, the switch automatically
resets.
Note
Do not interrupt the initialization process. Do not reboot the switch.
6. To download a file using Xmodem, type X at the prompt displayed in
Step 4.
The following prompt is displayed:
You are going to invoke the Xmodem download utility.
Do you wish to continue? [Yes/No]
7. Type Y for Yes.
The prompt “Downloading” is displayed.
8. Begin the file transfer of the new management software image.
Note
The transfer protocol must be Xmodem or 1K Xmodem.
Steps 9 through 12 illustrate how you would download a file using
the Hilgraeve HyperTerminal program.
9. From the HyperTerminal main window, select the Transfer menu.
Then select Send File from the pull-down menu, as shown in Figure
61.
Figure 61 Local Management Window