Allied Telesis AT-S39 - Manual (Page 232)

AT-S39 User’s Guide
232
The Settings for Port window is displayed. An example of the
window is shown in Figure 74.
Figure 74 Settings for Port Window
Note
Clicking the Default button returns the port settings to the default
values. Default values are listed in Appendix A, AT-S39 Default
Settings on page 293.
6. Adjust the port parameters as desired.
The parameters are described below.
Disable Port
You can use this check box to enable or disable a port. A disabled
port will not accept or transmit frames. The default for this port
parameter is enabled.
Speed and Mode
The operating speed and duplex mode of the port. Possible
settings for this parameter are:
❑ Auto-Negotiate: The port will Auto-Negotiate both speed and
duplex mode. This is the default.
❑ 10Mbps - Half Duplex
❑ 10Mbps - Full Duplex