Allied Telesis AT-S39 - Manual (Page 168)

AT-S39 User’s Guide
168
Activating IGMP Snooping
To activate or deactivate IGMP snooping on the switch and to configure
IGMP snooping parameters, perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type A to select Advanced
Configuration.
3. From the Advanced Configuration window, type 1 to select IGMP
Snooping Configuration.
The IGMP Snooping Configuration window in Figure 50 is
displayed.
Figure 50 IGMP Snooping Configuration Window
The options in the window are defined below:
1 - IGMP Snooping Status
Enables and disables IGMP snooping on the switch. After
selecting this option, type E to enable or D to disable this feature.
2 - Multicast Host Topology
Defines whether there is only one host node per switch port or
multiple host nodes per port. Possible settings are Single-
Host/Port (Edge) and Multi-Host/Port (Intermediate).
The Single-Host/Port setting is appropriate when there is only one
host node connected to each port on the switch. This setting
causes the switch to immediately stop sending multicast packets
Allied Telesyn Ethernet Switch AT-8024
Login Session: Manager
IGMP Snooping Configuration
1 - IGMP Snooping Status ......... Disabled
2 - Multicast Host Topology ...... Single-Host/Port (Edge)
3 - Host/Router Timeout Interval . 260 seconds
4 - Maximum Multicast Groups ..... 256
5 - Multicast Router Port(s) ..... Auto Detect
6 - View Multicast Hosts List
7 - View Multicast Router List
S - Save Configuration Changes
R - Return to Previous Men
Enter your selection: