Allied Telesis AT-S39 - Manual (Page 100)

AT-S39 User’s Guide
100
Enabling or Disabling STP or RSTP
To select and activate a spanning tree protocol, or to disable spanning
tree, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 27 is displayed.
Figure 27 Spanning Tree Menu
2. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
3. Type E to enable spanning tree or D to disable it. The default is
enabled.
4. To change the version of spanning tree protocol running on the
switch, type 2 to select Active Protocol Version.
Note
Changing the spanning tree version will reboot the switch.
The following prompt is displayed:
The switch will be rebooted for changing the
protocol version.
Do you want to continue? [Yes/No]
5. Type Y for yes to change the current version of spanning tree and
reboot the switch, or N to cancel this procedure.
6. If you deactivate spanning tree, type S to save your changes and
return to the Main Menu. If you activated spanning tree and you
selected STP, go to Configuring STP on page 101 for further
instructions. If you selected RSTP, go to Configuring RSTP on page
105
Allied Telesyn Ethernet Switch AT-8024
Login Session: Manager
Spanning Tree Menu
1 - Spanning Tree Status ...... Enabled
2 - Active Protocol Version ... RSTP
3 - STP Configuration
4 - RSTP Configuration
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?