Allied Telesis AT-S39 - Manual (Page 266)

AT-S39 User’s Guide
266
Setting the Switch’s VLAN Mode
This section contains the procedure for setting a switch’s VLAN mode.
You can configure a switch to support port-based and tagged VLANs or
to operate in the Basic VLAN mode.
Note
Refer to Chapter 10, Virtual LANs, for descriptions of port-based
and tagged VLANs and the Basic VLAN mode.
To set the switch’s VLAN mode, perform the following procedure:
1. From the Home Page, select Configuration.
2. From the Configuration menu, choose System.
3. Select the General tab.
4. In the Switch Mode section of the window, click either Tagged or
Basic.
If you select Tagged, which is the default, the switch will support
both port-based VLANs and tagged VLANs. If you select Basic, the
switch will operate in the Basic VLAN mode.
5. Click Apply.
6. Click Reset to reset the switch.
A change to VLAN status is not activated until the switch is reset.