Allied Telesis AT-S29 User Manual
Page 31
AT-S29 Management Software User’s Guide
31
IP Connectivity Test (Ping)
Use the IP Connectivity Test to see if another site on the Internet can be
reached. The screen shown below is described in the following table.
Default
Gateway
0.0.0.0
Gateway used to pass trap messages from the switch’s agent
to the management station. Note that the gateway must be
defined if the management station is located in a different IP
segment.
IP State
USER-
CONFIG
Specifies whether IP functionality is enabled via manual
configuration, or set by Boot Protocol (BootP). Options include:
USER-CONFIG - IP functionality is enabled based on the default
or user specified IP Configuration. (This is the default setting.)
BootP Get IP - IP is enabled but will not function until a BootP
reply has been received. BootP requests will be periodically
broadcast by the switch in an effort to learn its IP address.
(BootP values include the IP address, default gateway, subnet
mask, TFTP boot file name, and TFTP server IP.)
Parameter
Default
Description
Network Configuration IP Connectivity Test (Ping)
=================
IP Address
:
149.35.211.109
Test Times
:
1000
Interval : 1
Success
:
1000
Failure
: 0
[Start]
Use
Parameter
Description
IP Address
IP address of the site you want to ping
Test Times
The number of ICMP echo requests to send to the specified site
(1~1000)
Interval
The interval (in seconds) between pinging the specified site (1~ 10
seconds)
Success/Failure
The number of times the specified site has responded or not to pinging