Allied Telesis AT-S29 - Manual (Page 107)

AT-S29 Management Software User’s Guide
107
Port Menus
Port Information
The Port Information screen displays the port status, link state, the
communication speed and duplex mode, as well as the flow control in
use. To change any of the port settings, use the Port Configuration
menu. The parameters shown in the following figure and table are for
the RJ-45 ports.
Port Duplex Status
Full
Up
100M 1
2
3
4
5
Status
Enabled
Enabled
Enabled
Enabled
Down
Flow Control Status
Admin
Status
Link
Down
Down
Up
Status
Speed
10M
10M
10M
10M
Half
Half
Half
Half
Disabled
Enabled
Disabled
Disabled
Disabled
Disabled
Parameter Description
Admin Status Shows if the port is enabled or not.
Link Status Indicates if the port has a valid connection to an
external device.
Speed Status Shows the port speed (10M or 100M).
Duplex Status Displays the current duplex mode.
Flow Control
Status Shows the flow control type in use. Flow control
can eliminate frame loss by "blocking" traffic from
end stations connected directly to the switch.
Back pressure is used for half duplex and IEEE
802.3x for full duplex. Note that flow control
should not be used if a port is connected to hub.