Allied Telesis AT-S29 - Manual (Page 30)

Using the System Configuration Program
30
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure
the switch’s IP parameters. The screen shown below is described in the
following table.
Network Configuration IP Configuration
=================
Interface Type : Ethernet
IP Address : 149.35.19.10
Subnet Mask : 255.255.255.0
Gateway IP : 149.35.1.1
IP State : USER-CONFIG
Use or arrow keys to move, other keys to make
changes.
to toggle.
Parameter Default Description
Ethernet Interface
IP Address 10.1.0.1 IP address of the stack you are managing when accessing the
agent module over the network. The agent module supports
SNMP over UDP/IP transport protocol. In this environment, all
systems on the Internet, such as network interconnection
devices and any PC accessing the agent module are assigned
an IP address.
Valid IP addresses consist of four numbers, of 0 to 255, and
separated by periods. Anything outside of this format will not
be accepted by the configuration program.
Subnet Mask 255.255.0.0 Subnet mask of the agent you have selected. This mask
identifies the host address bits used for routing to specific
subnets.