Allied Telesis AT-GS950/24 - Manual (Page 315)

AT-GS950/24 Web Interface User Guide
315
Upgrade Firmware Image via TFTP
This section describes how to upgrade an firmware image of the AT-S109
Version 1.1.0 Management software using TFTP on an TFTP server.
Before downloading a new version of the AT-S109 Version 1.1.0
Management software onto the switch, note the following:
 The current configuration of a switch is retained when a new AT-S109
Version 1.1.0 Management software image is installed. To return a
switch to its default configuration values, see “Configure Factory
Default Values” on page 49.
 Your network must have a TFTP server.
 You must specify the path to the new AT-S109 Version 1.1.0 image file
on the TFTP server.
 Start the TFTP server software before you begin the download
procedure.
Caution
Downloading a new version of management software onto the
switch causes the device to reset. Some network traffic may be lost
during the reset process.
This procedure assumes that you have already obtained the software and
have stored it on the computer from which you will be performing this
procedure.
To download the AT-S109 Version 1.1.0 image software onto the switch
using a TFTP server, perform the following procedure:
1. From the menu on the left side of the home page, select the Tools
folder.
This folder expands to show contents of the Firmware Upgrade folder.
2. From the Firmware Upgrade folder, select via TFTP.
The Firmware Upgrade via TFTP page is shown in Figure 111.