Allied Telesis AT-GS950/24 - Manual (Page 199)

AT-GS950/24 Web Interface User Guide
199
Figure 73. Modify Port List Page
4. Change the parameters as required.
Note
See “Create Port List” on page 197 for the definitions of each
parameters.
5. Click Apply.
The modified Port List entry is displayed in the table at the bottom of
the page of the Create Port List page.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Delete Port List
To delete a Port List entry, perform the following procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select Port List.
An example of the Create Port List page with a Port List table entry is
shown in Figure 72 on page 198.
3. From the Create Port List page, identify which Port List table entry that
want to delete and click the Delete button in the Action column.
You will be prompted with a message saying, “Do you want to delete
Port List xxxxx?” (where xxxxx is the classifier index).
4. Click on the OK button.
The Port List entry is deleted from the Port List table.
5. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.