Allied Telesis AT-GS950/24 - Manual (Page 28)

Chapter 2: Basic Switch Configuration
28
IP Access List Configuration
When the IP Access List feature is enabled, remote access to the
AT-S109 Version 1.1.0 management software is restricted to the IP
addresses entered into the IP Access List.
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
 “Create an IP Access List” on page 28
 “Delete an IP Address List Entry” on page 30
Note
To modify IP address that has already been created, it must first be
deleted and them re-created using the following procedures.
Create an IP
Access List
To create a list of accessible IP addresses, perform the following
procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select IP Access List. The IP Access List
Page is displayed. See Figure 6.
.
Figure 6. IP Access List Page
3. Enter an IP address in the IP Address field using a xxx.xxx.xxx.xxx
format.
4. Click Add.
The IP address is added to the IP Access List table in the Accessible
IP column.