Static unicast mac address configuration – Allied Telesis AT-GS950/24 User Manual

Page 218

Chapter 15: MAC Address Table

218

Static Unicast MAC Address Configuration

This procedure explains how to set the static multicast feature for each
port on the AT-GS950/24 switch.

To add a static MAC address to the switch, perform the following
procedure:

1. From the main menu on the left side of the page, select the Bridge

folder.
The Bridge folder expands.

2. From the Bridge folder, select Static Unicast.

The Static Unicast Address Table Page is displayed. See Figure 81.

Figure 81. AT-GS950/24 Static Unicast Address Table Page

Before continuing, you must create an 802.1Q VLAN ID(s) or a Port-
Based VLAN Index(s). For information about defining these
parameters, go to:





“Port-Based VLAN Configuration” on page 91 regarding the Port-
Based VLAN Index parameter.

3. Select either the 802.1Q VLAN ID or Port-Based VLAN Index radio

button and enter the respective VLAN ID (1-4000) or VLAN Index (1 -
52).