Allied Telesis AT-GS950/24 - Manual (Page 139)

AT-GS950/24 Web Interface User Guide
139
Port Configuration
To configure the MSTP parameters for each of the ports, perform the
following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select the MSTP folder.
The MSTP folder expands.
4. From the MSTP folder, select MSTP Port Configuration.
A partial view of the AT-GS950/24 MSTP Port Configuration Page is
displayed. See Figure 46.
Figure 46. AT-GS950/24 MSTP Port Configuration Page
You may choose a port and configure its MSTP parameters on this
page. The following information is displayed:
Port - Indicates ports 1 through 24 on the AT-GS950/24 switch.
Use the All row to apply the same settings for the Point-to-Point
Status, Edge Port, MSTP Status, Protocol Migration, AutoEdge
Status, Restricted Role, Restricted TCN fields to all the ports on
your switch.
Path Cost - Specifies the cost of a port to the root.
Priority - Specifies the spanning tree port priority.
PointToPoint Status - Indicates if the port is connected to another
network device (point-to-point) in the network topology. See “Point-
to-Point and Edge Ports” on page 118 for more information.
ForcedTrue - The port is connected to a network device in the