Allied Telesis AT-GS950/24 - Manual (Page 173)

AT-GS950/24 Web Interface User Guide
173
Mapping CoS Priorities to Egress Queues
Before mapping the CoS priorities and the egress queues, you must
disable the Jumbo frame parameter on each port. See the Jumbo
parameter definition in “Display and Configure Ports” on page 63.
Note
When Jumbo frames are enabled, COS can not be enabled.
To configure CoS mapping, perform the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select QoS.
The QoS folder expands.
3. From the QoS folder, select CoS.
The CoS Page is displayed. See Figure 55.
Figure 55. CoS Page