Allied Telesis AT-GS950/24 - Manual (Page 274)

Chapter 20: Simple Network Management Protocol SNMPv1 and v2c
274
6. Click Add.
The new host is added to the table.
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modify Trap
Host Table Entry
If you need to modify an SNMP Trap entry, you must first delete the entry
by using the procedure below and then re-enter it with the modification by
creating a new SNMP trap- see “SNMP Traps” on page 273.
Delete Trap Host
Table Entry
Use the following procedure to delete a Host table entry:
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Management.
3. The Trap Management Page is displayed. See Figure 97 on page 273.
4. To delete an entry in the host table, click Delete next to the entry in the
table that you want to remove.
The Host table entry is removed from the table. No confirmation
message is displayed.
5. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.