Allied Telesis AT-GS950/24 - Manual (Page 286)

Chapter 21: Simple Network Management Protocol SNMPv3
286
5. Enter “1” for the OID Mask.
6. Enter the View Type. This can be one of two choices:
Included - This selection allows the specified MIB object to be
included in the view.
Excluded - This selection blocks the view of the specified MIB
object.
7. Click ADD.
The new view is displayed in the View Table.
8. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modify SNMPv3
View Table
Entries
If you need to modify an entry in the View Table page, you must first
delete the entry and then re-enter it. For information about how to delete
an entry in this table, see “Delete SNMPv3 View Table Entries”. For
information about how to create a new entry in this table, see “Create
SNMPv3 View Table Entries” on page 285.
Delete SNMPv3
View Table
Entries
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select View Table.
The SNMP View Table page is displayed. See Figure 101 on page
285.
In the Action column of the table, click Delete for the View table entry that
you want to remove.
Note
The views corresponding to the ReadOnly and ReadWrite Group
Names are default values and cannot be removed.
3. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.