Allied Telesis AT-GS950/24 - Manual (Page 142)

Chapter 9: Multiple Spanning Tree Protocol
142
Port Settings
To configure the MSTP port settings, perform the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select the MSTP folder.
The MSTP folder expands.
4. From the MSTP folder, select MSTP Port Settings.
The MSTP Port Settings Page is displayed. See Figure 47.
Figure 47. MSTP Port Settings Page
You may choose a port and configure its MSTP parameters on this
page. The following information is displayed:
Port - Indicates ports 1 through 24 on the AT-GS950/24 switch.
Use the All row to apply the same settings for the Port State field
to all the ports on your switch.
MSTP Instance ID - Indicates the MSTP Instance that associated
with this port.
Port State - This parameter activates or deactivates the port.
Select one of the following choices from the pull-down menu:
Enable - Allows the port to forward packets.
Disable - Does not allows the port to forward packets.
Priority - This is the port priority used by MSTP in calculating path
costs when two ports on the switch have the same port cost.
Cost - This is the port cost used by MSTP when calculating path
cost to the root bridge.
5. Once you have configured the parameters, click Apply in the Action
column.