Allied Telesis AT-GS950/24 - Manual (Page 126)

Chapter 8: STP and RSTP
126
Configure RSTP Port Settings
This section contains the following topics:
 “Configure the Basic RSTP Port Settings”
 “Configure the Advanced RSTP Port Settings” on page 128
Configure the
Basic RSTP Port
Settings
To configure the basic RSTP port settings, perform the following
procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select the RSTP folder.
The RSTP folder expands.
4. From the RSTP folder, select the RSTP Basic Port.
A partial view of the AT-GS950/24 RSTP Basic Port Configuration
Page is displayed. See Figure 41.
Figure 41. AT-GS950/24 RSTP Basic Port Configuration Page
This page displays the following information about the ports:
Port - Indicates ports 1 through 24 on the AT-GS950/24 switch.
Use the All row to apply the same settings for the STP Status,
Priority, and Path Cost fields to your switch.
Trunk - Indicates the trunk assignment of a port.
Link Status - Indicates if the port link status is active (Up) or
inactive (Down).
Port State - Indicates one of the following port states:
Blocking - A blocking state does not allow network traffic to be