Allied Telesis AT-GS950/24 - Manual (Page 270)

Chapter 20: Simple Network Management Protocol SNMPv1 and v2c
270
Note
If you choose to use the default User and Group Names (ReadOnly
and ReadWrite) that are already displayed in the table, proceed to
step 7 below.
3. Type a new User Name.
Enter a name up to 31 characters in length.
4. Type a previously defined Group Name.
Enter a name up to 31 characters in length.
5. Select the SNMP Version of either v1 or v2c.
Note
The encryption check-box and Auth-Protocol, Priv-Protocol, and
password fields are intended for SNMPv3 configurations only and
are not used for SNMPv1 or v2c configurations.
6. Click Add.
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modify SNMPv1/
v2 User and
Group Names
If you need to modify an entry in the SNMP User/Group page, you must
first delete the entry and then re-enter it. For information about how to
delete an entry in this table, see “Delete SNMPv1/v2 User and Group
Names”. For information about how to create a new entry in this table, see
“Create SNMP v1/v2 User and Group Names” on page 269.
Delete SNMPv1/
v2 User and
Group Names
This procedure explains how to delete an entry on the SNMP User/Group
page.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select SNMP User/Group.
The SNMP User/Group Page is displayed. See Figure 95 on page
269.
3. In the Action column of the table, click Delete for the User Name and
Group Name that you want to remove.
4. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.