Allied Telesis AT-GS950/24 - Manual (Page 195)

AT-GS950/24 Web Interface User Guide
195
Modify Out-
Profile Action
To modify a Out-Profile action entry, perform the following procedure:
Note
Before you can modify an entry, you must first enter a Out-Profile
action - see “Create In-Profile Action” on page 189.
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select Out-Profile Action.
An example of the Create Out-Profile Action page with a Out-Profile
Action table entry is shown in Figure 69 on page 194.
3. Select the table entry that you want to modify and click the modify link
in the Action column.
The Modify Out-Profile Action page will be displayed. See Figure 70.
Figure 70. Modify Out-Profile Action Page
4. Change the parameters as required.
Note
See “Create In-Profile Action” on page 189 for the definitions of each
parameters.
5. Click Apply.
The modified Out-Profile action entry is displayed in the table at the
bottom of the page of the Create Out-Profile Action page.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.