Horner APG QX751 OCS User Manual
Page 46
CH.9
MAN0890-02-EN
August 20, 2009
Page 46 of 96
ECN # 979
View Protocols
The View Protocols Sub-Menu displays three System Settings, none of which are editable.
As mentioned earlier, MJ1 (Port 1), MJ2 (Port 2), and CN1 (Port 3) serial ports support downloadable
protocols. To assign a downloadable protocol to an QX751 serial port, select the Protocol Config item in
Cscape’s Program menu and then setup a protocol for Port 1, Port 2, or Port 3 (or all of them).
In the View Protocols Sub-Menu, the currently downloaded protocol, if any, and its version number are
displayed for the respective port.
Port 1:
Protocol name
= (None Loaded) or name of the protocol assigned to MJ1
Protocol version
= Blank or version of the protocol assigned to MJ1
Port 2:
Protocol name
= (None Loaded) or name of the protocol assigned to MJ2
Protocol version
= Blank or version of the protocol assigned to MJ2
Port 3:
Protocol name
= (None Loaded) or name of the protocol assigned to CN1
Protocol version
= Blank or version of the protocol assigned to CN1
Set Fkeys
The Set Fkeys Sub-Menu displays two System Settings, both of which are editable.
Fkeys: Momentary
(default) = %K1-7 bits go On/Off as F1-F7 are pressed & released
Toggle = %K1-7 bits toggle each time F1-F7 are pressed
SYS_Fn enable: Yes
(default) = Reset and all clear system functions enabled
No = Reset and all clear system functions disabled
Set RS232 Mode
The Set RS232 Mode Sub-Menu displays one System Settings, which is editable.
RS232 mode: CsCAN
(default) = puts MJ1 in Cscape application programming mode
Update = puts MJ1 in FW Update mode
Set Time/Date
The Set Time/Date Sub-Menu displays three System Settings. Time and Date are editable, and Day is
automatically calculated from the Date setting. Note that Time and Date are split into three editable fields
each. Use
←
or
→
to select a field and then use
↓
or
↑
to edit the field.
Time:
10:21:36 = Current time (hh:mm:ss in 24-hour format)
Date:
22-Jun-2006 = Current date (dd-md-yyyy)
Day:
Thursday = Current day of week calculated from the Date setting