Horner APG QX751 OCS - Manual (Page 29)

MAN0890-02-EN CH. 7
August 20, 2009 Page 29 of 96 ECN # 979
CHAPTER 7: SMARTSTACK I/O
7.1 General
Chapter Seven provides preliminary configuration procedures, which are common to all SmartStack
Modules.
Note: Because the configuration parameters are different for each SmartStack Module, refer to the data
sheet that is sent with the product and is specific to the selected module.
7.2
Configuration Procedures
Note: SmartStack Modules use Cscape Software for configuration.
1.
From the Main Menu, select Controller | I/O Configure.
Note: The look of the screen varies depending upon the type of controller that appears.
2.
First, ensure that the desired controller is selected.
In this case a different controller than the one shown on the screen might be desired. It is then
necessary to select the desired controller, which is the QX751 BP43 In this example
configuration. Continue with Step 2.
However, if you are satisfied with the controller selection, press a Base # tab. Go to Step 3
Figure 7.1 - Main Configuration I/O Screen
Note: The Auto Config System button can be pressed prior to selecting the desired controller and I/O.
By pressing the button, the settings are deleted from any controller and I/O that is physically connected to
the PC. A dialog box appears and indicates that settings will be deleted from currently configured
models. If OK, press Yes. Then press OK.
Slot