Horner APG QX751 OCS - Manual (Page 43)

MAN0890-02-EN CH. 9
August 20, 2009 Page 43 of 96 ECN # 979
Set Contrast
The Set Contrast Sub-Menu displays, however for the QX751line there are no adjustments available on
this sub-menu.
View OCS Status
The View OCS Status Sub-Menu displays up to 17 System Settings. The OCS Net Use (%) and All Net
Use (%) System Settings only appear for QX751 models that have a BPxx attached. Only the Mode
System Setting is editable.
Model: QXx51 x - indicates the size of the display
x - 4 = 8”; 5 = 10”; 6 = 12”
or
QXx51BP4y
y - indicates whether the high speed I/O is installed
y - 1 = Not installed; 3 = Installed
Mode:
Idle = QX751 is in Idle mode
DoIo = QX751 is in Do I/O mode
Run = QX751 is in Run mode
Scan Rate(mS):
0.0 = QX751 is not in Run mode
0.1 to 999.9 = Average number of mS for each ladder scan
OCS Net Use (%): 0.0 to 100.0
= CAN network bandwidth % used by this QX751node
All Net Use (%):
0.0 to 100.0 = CAN network bandwidth % used by all nodes
Ladder Size:
x = Number of bytes in application ladder program
Config Size:
x = Number of bytes in application I/O configuration
Graphics Size:
x = Number of bytes in application graphic screens
String Size:
x = Number of bytes in application string table
Bitmap Size:
x = Number of bytes in application bitmaps
Text Tbl Size:
x = Number of bytes in application text tables
Font Tbl Size:
x = Number of bytes in application font tables
Protocol Size:
x = Number of bytes in application downloaded protocols
SMS Size:
x = Number of bytes in application SMS configuration
Firmware Rev:
xx.yy = Current firmware version
BIOS Rev:
x.y = Current BIOS (Basic Input/Output System) version
FPGA Rev:
x.y = Current FPGA (Field Programmable Gate Array)
version
Self-Test:
Ok = All power-on self-tests passed